Guide

Building Code compliant tiny homes in NZ: what it means and how to check

If your tiny home is a building, it has to meet the Building Code whether or not it needed a building consent. A home on wheels is outside it only while it stays a vehicle. "Building Code compliant" on a listing is a claim, not a certificate: the proof is the consent and code compliance certificate, or the LBP records of work.

Last checked 15 September 2026 against Tiny Houses guidance, fifth edition, January 2026

Updated · About 7 minutes to read

Code clause groups
8
A to H, structure to energy
Consent needed?
Not always
the Code applies anyway
Granny flat cap
70 m²
exempt, still full Code
On wheels
2-part test
immovable and lived in

Do tiny homes have to meet the Building Code in NZ?

Yes, every tiny home that counts as a building does. MBIE: "All building work in New Zealand must meet the performance criteria of the Building Code, even if it does not need a building consent." A consent exemption removes the council's check, not the standard. The only tiny homes outside the Code are ones that are genuinely vehicles, and that status can change with how the home is used.

What does the Building Code actually cover?

The Building Code is performance-based. In MBIE's words it "states how a building must perform in its intended use rather than describing how the building must be designed and constructed", and it sets a minimum you can exceed but not go under. It lives in Schedule 1 of the Building Regulations 1992 and is split into eight clause groups. For a small home, these are the parts that matter in practice:

The Building Code clause groups, and what each means for a tiny home
Clause groupWhat it coversWhere a tiny home usually meets it
A General provisionsDefinitions and how buildings are classifiedA granny flat is classified as Housing – detached dwelling, so the full dwelling requirements apply
B StabilityStructure (B1) and durability (B2)The frame, foundations or tie-downs, and wind bracing for an exposed site
C Protection from fireFire spread and escapeSeparation from the main house and boundaries, and a way out from a loft
D AccessGetting into and around the buildingStairs and ladders to sleeping lofts, and floor-level changes
E MoistureSurface water, external moisture (E2) and internal moisture (E3)Cladding and flashings that keep rain out, and ventilation that stops a small, well-sealed space getting damp
F Safety of usersHazards including warning systems (F7)Smoke alarms, especially where people sleep
G Services and facilitiesKitchens, bathrooms, ventilation, water supplies (G12) and foul water (G13)Plumbing, drainage, hot water and the wastewater route, including composting toilets
H Energy efficiencyInsulation and thermal performance (H1)Insulation levels in walls, floor, roof and windows, which bite hard on a small, exposed box

Clause groups from building.govt.nz: How the Building Code works (last updated 28 January 2026, read 31 October 2026). The right-hand column is our plain-English summary, not the Code's wording; your designer works to the clauses themselves.

Does a tiny house on wheels have to meet the Building Code?

Only if it is a building, and wheels alone do not decide that. MBIE: "Building a tiny house on a trailer/on wheels does not automatically make it a vehicle; there are other factors that you need to consider." Under section 8 of the Building Act, a vehicle that is immovable and lived in long-term is a building, and then the Code applies to it. See the full test on tiny houses on wheels.

Two things catch people out. First, connecting to services: MBIE says "You will need to obtain a building consent to connect to existing network utility operator (NUO) systems such as potable water, storm water and wastewater", whatever the home sits on. Second, a home sold as a vehicle that later becomes a building has no consent record behind it, so nothing shows the work was checked against the Code.

Which route is your tiny home on, and what proves it complies?

The route sets who checks the home and what paper you end up holding. On the consent route the council inspects and signs off; on the exempt routes nobody inspects, so the records of who built it are your evidence. Read across the row for your home:

Consent route against who checks it and the paperwork it leaves you
RouteDoes the Code apply?Who checks the workPaperwork to hold
Building consentYes, in fullThe council, through inspections during the buildThe building consent, the code compliance certificate once the work is signed off, and LBP records of work
Granny flat exemption, up to 70 m²Yes, in full, as a detached dwellingNo consent inspections; the council is told before and afterLBP certificates and records of work for the restricted building work, plus plumbing, electrical and any gas certificates. No code compliance certificate, because there is no consent
Schedule 1 exemptions, 10 to 30 m², no bathroomYesNobodyFor 3B, the LBP's records; for 43, the engineer's design review behind the kitset
On wheels, kept as a vehicleNo, while it stays a vehicleNZTA rules on the roadA warrant of fitness for the trailer, plus electrical and gas certificates for what is inside
On wheels, now a buildingYesThe council, if anyone asks itOften nothing, which is the risk. Talk to the council before you buy one in this state

Routes and LBP requirements from the MBIE Tiny Houses guidance (fifth edition, January 2026) and building.govt.nz: Building consents, development contributions and using licensed professionals (last updated 15 January 2026, read 31 October 2026).

What paperwork should I ask a tiny home builder for?

How to check a tiny home builder's Building Code compliant claim

  1. Ask which route the home is on, in writing

    Building consent, the 70 m² granny flat exemption, a Schedule 1 exemption, or a vehicle. "Compliant" means something different on each, and a builder who cannot name the route is telling you something.

  2. On the consent route, get the consent and the CCC

    Ask for the building consent number and, once the work is finished, the code compliance certificate. Your council can confirm both against its own records for your address.

  3. Check the LBPs on the public register

    Restricted building work, the structure and weathertightness, must be designed, built or supervised by a Licensed Building Practitioner. Ask for their names and check each one on the LBP register.

  4. Get a record of work from each LBP

    MBIE: "each LBP who carries out restricted building work on your home must provide a Certificate of Work and a Record of Work, where applicable." On an exempt build, this is most of your evidence.

  5. Get the gas and electrical certificates

    Plumbing, gasfitting, drainlaying and electrical work must be done by qualified people even on an owner build. For gas, MBIE says a certifying gasfitter "must issue a gas safety certificate and certificate of compliance". Ask for the electrical certificate of compliance too.

  6. Ask whether the design holds a MultiProof

    If the builder repeats a standard design, ask whether it is on the MultiProof register. It speeds up consent; it does not replace it.

Does MultiProof or BuiltReady mean a tiny home is compliant?

They help, but neither is a sign-off for your home. MultiProof is "a statement by the Ministry of Business, Innovation and Employment (MBIE) that a set of plans and specifications for a building complies with the Building Code", and MBIE adds that "You still need to apply for consent each time you want to build". BuiltReady is a "voluntary modular component manufacturer scheme" for factory-built components, and MBIE says officials are considering its ongoing role.

Who is responsible if an exempt tiny home does not comply?

You are, as the owner. MBIE: "You as the owner are responsible for ensuring that any restricted building work is carried out by an LBP." On an exempt build there is no council inspection to catch a problem, so a defect shows up later: when you sell, insure or try to connect services. Insurers ask the same questions; see who insures tiny homes.

Frequently asked questions

Do tiny homes need to meet the Building Code in NZ?

Yes, if the tiny home is a building. MBIE says all building work must meet the Building Code's performance criteria even if it does not need a building consent. A tiny house on wheels is outside the Code only while it remains a vehicle.

Does a granny flat built under the 70 m² exemption have to meet the Building Code?

Yes, in full. MBIE classifies it as Housing – detached dwelling. The exemption removes the building consent, not the standard, and restricted building work still needs a Licensed Building Practitioner.

Does an exempt tiny home get a code compliance certificate?

No. A code compliance certificate is issued at the end of a building consent, so a home built under an exemption has none. Its evidence is the LBP certificates and records of work, and the plumbing, electrical and gas certificates.

Is a tiny house on wheels Building Code compliant?

The question only applies if it is a building. Wheels do not automatically make it a vehicle; under section 8 of the Building Act a vehicle that is immovable and lived in long-term is a building, and then the Code applies.

What is MultiProof for tiny homes?

An MBIE statement that a set of plans and specifications complies with the Building Code, for designs that get built repeatedly. It speeds up consent, but you still need a building consent each time the design is built.

Start here

Not sure where you stand? Answer six questions.

The checker tells you which rule your build falls under and links you straight to it. Free, and it doesn't ask for your email.